Originally posted by MIdnight95SE:

Now about the corners. To make a long story short it kind of happened on accident. I was working on my bumper, and it put so much pressure on the corner, the lense popped cleanly off the plastic fixture. I tried to figure out a way to remove it, but no luck. So I turned to the trusy Dremel. I put the sander bit on it, and started shaving the reflector away. After it was all gone I sanded in inside of the lense as well as I could. Up close you can still see where the dremel went a little deeper than it should have. Anyhow, it looks pretty cool.


I've been itching to do the exact same thing, I was just too concerned that the clear layer that was left would be too thin and easily break. But it looks good. How thick do you think the clear is that is left? Well, you car looks killer, definately low, but I likey. Now off to find some extra corners to tinker with now that it's cold.