Well, along the sides where the 2 bolts go into the fenders I got some 1/8" thick by 1" wide steel bar from Home Depot and cut it to run the whole length of the lip under the bumper where it bolts up to the fender. Then drilled the holes to match up w/ the ones in the fender and bumper and bolted it up. The steel strap is very ridgid and pulls the whole bumper up tight and snug against the front fender. when I had put the bumper on w/o any additional supports or tried to just use the black plastic brace off of the orig bumper, it sagged horribly and the contour line area angled down then. That is why I opted to try something more ridgid and guess what, it seemed to work.