Again, out of the Ford Service Manual, in reference to the front subframe:
Front Sub-frame Alignment
6. Install A/C accumulator retaining bracket screw to the front sub-frame. Tighten screws securely.
7. Connect power steering oil cooler hoses at RH front of front sub-frame. Secure hose clamps securely.
8. Install Powertrain Alignment Gauge T94P-6000-AH or equivalent to LH front engine support bracket (6028) and front sub-frame. Tighten two retaining bolts to 27 N-m (20 lb-ft) and through bolt snug.
9. Remove Three Bar Engine Support D88L-6000-A or equivalent.
10. Install RH front engine support insulator with retaining bolts to front sub-frame and through bolt. Tighten two retaining bolts to front sub-frame to 41-55 N-m (30-41 lb-ft) and through bolt to 103-137 N-m (75-102 lb-ft). Observe position of RH front engine support insulator. It must be centered in bracket and in perfect alignment front to rear.
11. Remove Powertrain Alignment Gauge T94P-6000-AH.
12. Install LH front engine support insulator to front sub-frame with two bolts. Tighten bolts to 10 N-m (7 lb-ft). Observe LH front engine support insulator to ensure perfect front to rear alignment. Re-tighten bolts to 41-55 N-m (30-41 lb-ft). Install LH front engine support insulator through bolt. Tighten to 103-137 N-m (75-102 lb-ft).
13. Install stabilizer bar link to front stabilizer bar. Install and tighten retaining nuts to 47-65 N-m (35-48 lb-ft).
14. Connect front suspension lower arm at pinch bolts to ball joints. Tighten bolts to 50-58 N-m (37-43 lb-ft).
15. Connect steering gear to steering column and install pinch bolt. Refer to «Section 11-04».
16. Install catalytic converter. Refer to «Section 09-00».
17. Install LH and RH tie rod ends (3A130) onto front wheel knuckle. Refer to «Section 11-02».
18. Install tires and wheels (1007). Refer to «Section 04-04».
19. Install front bumper cover braces to LH and RH side of front sub-frame. Tighten bolts securely.
20. Install radiator supports to front sub-frame. Tighten bolts to 8-11 N-m (71-97 lb-in).
21. Install splash shield at front of front sub-frame. Tighten retaining screws securely.
22. Lower hoist.
23. Remove safety wire retaining radiator and engine cooling fan motor, fan blade and fan shroud assembly to the radiator support.
24. On 2.0L engine equipped vehicles, install exhaust manifold shield and oil level dipstick. Tighten retaining bolts to 8-12 N-m (71-106 lb-in). On 2.5L engine equipped vehicles, install water pump pulley shield. Tighten retaining bolts securely.
25. Connect battery ground cable.
26. Fill power steering system with Premium Power Steering Fluid E6AZ-19582-AA or equivalent meeting Ford specification ESW-M2C33-F. Refer to «Section 11-02». Run engine and check for leaks.
27. Check front end alignment. Adjust if necessary. Refer to «Section 04-00».
