Originally posted by Antonio Wright:
Well the fact is that AUTOLAMPS-ONLINE.com has to modify the plug to accept the 9006 bulb. I bet you did not know that dumbass. In regards to faulty installation I doubt that because if there was no serious flaw in the plug design I don't think Philipâ??s would have changed their design.
To be accurate, Philips didn't change their design. Rather, Autolamps modified the Philips ballasts to accept their modified 9006 bases, and now, their custom pigtails.
Originally posted by Titan:
Now that sounds like an idea. How would one go about doing this, just cut out the stock assembly and glue in a projector lens? Also where would be a good place to find sed lenses....junk yards?
I have projectors, waiting on a set of new headlight assemblies to put them in. The lens in the projector is set in front of the parabolic reflector, so I still need to figure out how to block waste light. Factory HIDs have a chrome shroud in the headlight assembly. Milan, mind if I ask what you're using?
