GEEEZ , that sux he did that ,
well i will try to get you the best details ......
here we go !!
upper part of your dash there is 2 screw's take them out with a #2 Phillups screwdriver., and in the middle of the card where it sayd Contour and there is a little red light that blinks, take a flat tip screwdriver and pop that out , youll see another screw in there...now on the left side of the dash there is 2 push buttons, pop them out and youll see another screw in there ....take this out as well .
now you should be able to take off the outside part of your dash panel ....
now look inside there , youll see screws holding the main dash in there, just take these out also but dont start losing screws now
.......in the back youll have 2 seperate wiring harness, unclip both of there, dont worry you cant mix them up when you put them back on .....now you should be ready for the dash to come out !!
once you have it out flip it on its side, you'll see a couple little plastic clips holding the clear lens to the housing ...pop it off carefully ....
now that your in the inside of the dash , take you tach and speed gauges "indaglo" and try it slide it over the needles BE CAREFUL !!! and do the same to the tach as well , and the other pieces put them over your exsisting ones .....follow the reversed procedure on putting it back together .......
i know i may have skipped a few tiny spots here ...but just ask if you dont understand
