Originally posted by crank:
"V brackets are held on with one bolt" Where???? Center, where the big side to side bushings are held! (Sway bar bushing clamps) Thanks for being specific! 
When I push on my rear tire sideways, there is a loose clicking sounds/play. I took wheel off and religned and torqued. Same problem!! I don't here the GGrrrrr sound but I do hear clunking on cornering. Could the rear wheel bearing on corners cause the clunking sound? What else would cause the rear wheel to move a bit as I press sideways on it with my foot??? As always, thanks in advance!!!!! 
Sorry I didnt get into specifics in that last post, but what I was referring to was the sway bar U-brackets.
There is one bolt holding the U-brackets to the frame; as a result, weld seem like the only solution when a bigger 22mm sway bar is installed with the STOCK brackets.
I hope this clears up in any confusion.
And you might want to check your rear spring to see if it is broken.
You will physically have to raise the vehicle and remove the wheel in order to see.
