The one place I had the most trouble with was finding the last screws. I'm sure you got off all the screws around the edges/under but didn't know about the 2 huge screws inside the handle! I hacked up my handle a bit and I don't think there is any way to avoid it but the part if you damage it is very cheap. What you need to do is take the center area out of the handle. It looks like it is one peice but the part inside the stretched out oval is actually a plastic snap in. It has the qualities of tupperware so be carefull when getting it off. The best place to pry it off would be from the bottom center using a very small screwdriver or butter knife. You need to jimmy it a bit to get it up, under and in. then tilt the handle down. You'll notice a gap and using the dull side of the butter knife slide it to the right or left. While you're in there I'd replace the green light bulb. They have a habbit of burning out. Or do what I did and replace it with blue LED bulb which will never burn out and looks very nice. You'll have to change all that way but you'll most likely never need to take the panel off again. Once you get the hang of it it's easy. It's just a matter of getting all the screws and sort of lift and pull towards the inside of the car. Oh and by the way, ROLL DOWN THE WINDOW FIRST!
