Originally posted by TheGreatOne:
What kind of cups do you put in there!? My problem with theh cup holders is that they are too damn big and if I take a turn at anything over .02 mph I have to catch my drink before it hits the floor and spills all over the place. I've learned to drive with one hand on the wheel and onehand on whatevers in the cup holder to prevent it from spilling. Taking out the rubber would only make the problem worse!
no it doesn't make it worse..all you have to do is try it pull it out,and you'll see what i mean...the hole underneath the rubber is deeper,and it gets skinnier also...it is wide and then it gets narrow at the bottom...the narrow part is about the width of a can,and it holds cans and just about any kind of fast food cups,particularly the tapered cups,the shape underneath is the same shape as the tapered cups..but don't take my word for it,take the 2 seconds it takes to pull it out and you'll see what i mean..you don't know until you look at it..all it takes is a second to pull it out...but go ahead and waste your money on after market solutions,because you are too hardheaded to spend 2 secs. pulling out the rubber and looking at it...i'm just trying to give some free advice here,its simple and its free,and i haven't spilled a drink yet since removing it...
