Originally posted by radioactive:
Burgman,
Here are the directions:
1. Empty and remove glovebox (Squeeze both sides in and drop down. Should pull straight out)
2. Locate resistor pack (should be towards the left side while looking in. You will see a white pack with a wiring harness attached to it)
3. Remove one torx screw, disconnect wiring harness, and toss the old pack.
4. Check the conditions of the wiring to make sure they are in good shape.
5. Installation is reverse of above procedure.
Note: Check to make sure you don't have the car on and the HVAC switch on. The resistor will get very, very hot.
Let me know if you have any questions.
Thanks for the step by step. It looks to be a very simple job. As soon as I get the part Iā??ll put it in and report back. Bill has not responded to my e-mail so Iā??ll call him on Monday.
