I have it. They didn't do their math right and the dipstick doesn't go back in the "notch" in the stock piece, so your oil level reading is no good. You'll have to install it, jab the dipstick into the pan a few times to get marks to show you where to cut, remove it and cut the notch bigger, and then reinstall. The only reason I realized this was that I had to drop my oil pan to replace the gasket. Poor design on that point IMO, but otherwise its a nice little piece. Wish I had brought my camera when I did that, but I wasn't expecting to discover that problem, and I'm not dropping the oil pan again.
