I still haven't got the e-RAM installed, but I did start installing the switch for it... and I discovered that they use a cheap flimsy switch.

I think I'm going to make an electronic switch triggered by the throttle position sensor. Something like this:

96 GL Zetec ATX, white with pinstripe, nickname " Sam Smooth "
mods so far: CTA intake with homemade heat shield, KVR drilled front rotors & carbon pads w/ 500° fluid
planned mods: exhaust (want to keep it quiet), e-ram (awaiting installation), diablo chip
involuntary mods: compression increased after head gasket failure