I know I've seen a few members post their interest in getting an aluminum bezel for the shifter bracket and I've been researching and I can have these made through my dad's tool and die shop. Preliminary prices look to be $15-20 (maybe less pending on die complexity) per bezel and they would be attached via 3M double sided tape.
If these sell well, trim rings will be made available for all of the door pulls and handle surrounds, but interest has to be here for the shifter bezel before I could offer any other pieces.
Again, these would be made out of REAL brushed aluminum, not aluminum colored plastic.I need to see sufficient interest before I'll pay the money for the die so if you want one make sure to post!
