Tom,


Shouldnt I be concerned with using valvetrain components from my 2.5L since it will have over 50,000 miles on it by then?

Also, I didnt see roller finger followers listed on their site or in their diagram of the heads. I wonder where I can find the part number for those. How many would I need of those, 24, one for each valve?

So the trick is to use the 32mm Intake Valves from the 2.5L as exhaust valves on the 3.0L I will definitely look into that as it wont cost me any extra money to buy one set of valves over another. Well worth it in my opinion....

Between You, Brad, and Terry, I am getting tons of info...this will make the job so much easier for me. Thanks alot, and keep it coming!!!


Nikolas

1999 Mercury Cougar V6
KKM Intake,SVT TB, SVT Upper/Lower, 19lb injectors, Diablo Chip, MSDS Headers, Custom Exhaust, B&M Short Shifter, Progress Lowering Springs, 18" Axis TC's, OMP Strut Bar, AAM 24mm Rear Sway Bar, Koni Struts

15.09 @ 91.54(corrected, pre-SVT conversion, DiabloChip, and Injectors)