Well,

I just read through the instructions of removing the rear crossmember and it is not something I want to attempt.

Remove exhaust, remove gas tank, remove rear springs, etc. I will look at it again tomorrow.

Two options: Remove the Bar permanately, or try to weld a new bracket with crossmember in situ.

Terry-
What torque setting should I tighten the
End link to front lower arm:
Stabilizer bar to end link:
Prothane Bracket to cross member:

Thanks


98 T-Red Contour LX V6 Mtx 106k miles
9" K&N, Aussie Pipe, Dual Mode Damper, 19lb. injectors, SHM MAFterburner, Ford 9mm Wires, Mystery Mod, ShoShop Off-road Y pipe, Dynomax Resonator and Muffler, 2.5" custom cat-back.