Basically he cut four slits into the top of the tower going from the outer edge to the middle, so now his tower looks like a 4 slice pizza, then he took a BFH and pounded on the towers until they were flat, next is to weld your cuts back up, grind to a nice finish and mount your camber/caster plates.  gutsy...
Marco Tatta
98.5 SE MTX, Duratec
EGR block, fog light
fix, custom shift boot, monsterflow intake, Ecotek valve
Quasi dual cardoctor exhaust.
Hacksaw short shift, Momo race "s" carbon knob, ghetto rear strut bar, 16 inch cougar wheels with 225/50/16 kumho 712s
| 
