Well, I just spent the day putting the new BAT euro handling kit in.
The installation was straightforward and would only have taken about 3.5 hours except I had to have someone press a new right front wheel bearing in. That sucked. I had to get in line so to speak and wait 4 hours before they had time to get to it.
I also installed new axle nuts on the front, that's a must do.
***************************
My first impressions: WOW!
***************************
It feels great on the regular road. The ride is not harsh, feels pretty similar to my old 95 SE, except maybe a bit tighter.
Squat and Dive? Gone! I don't think that I will be worrying about destroying my plastic now.
This is what SVT should have done from the beginning. Turning is much better than stock. NO DRAMA going around a corner at high speed now.
This is a very well matched suspension kit.
It doesn't look too low either. I am running the stock rims, and it makes them look more properly sized. With big rims it would look even lower.
So my suspension setup is the BAT euro kit, and the larger BAT rear sway bar(22mm I think).
Thanks a lot Chris.
warmonger
