Terry: I agree it was overkill considering I had a little trouble at first with the weld being too hot and blowing holes in the subframe! BTW- I like the I-beam and coffee can reference, I'm usually one for overkill!
Munson:
I used the brackets and little drawing that Stazi supplied me with the Aussie Bar. I ran it for over a month on my silver car before it got totalled. I'm sure he can give you the hook up on where he was getting the urethane bushings and brackets that go with them.
I took the bar off my silver car before it got towed off and haven't had a chance to put it back on the new car yet. A greasable bushing would be nice. I would think you could fab one yourself without much difficulty. Just drill and tap your bracket for a grease zirc and then drill a small hole in the urethane directly below it to allow for grease to get between the bar and the bushing.
Rick
