Originally posted by Trapps:
Justin,
your 310rs.2's are DVC and your PH30 is:
watts/ channel 4 ohm: 75 x 6
watts/ channel 2 ohm: 110 x 4 + 150 x2
watts/ bridged 4 ohm: 220 x 2 + 300 x 1
How did you wire the system? The subs in particular?
Thanks,
Mark
I ran 2 channels of the Amp to set of Components (Front) and the other 2 channels to as coax set(Rear Fill).
The remaining two channels are bridged and running to my subs which have the VC's wired in Parallel then each sub is wired in series. Allowing for a 4ohm mono load. I believe the amp is underrated quite a bit because it pushes the subs nicely. I'm sure I could use a bit more power to them but they satisfy my tastes nicely.
If you have any more questions let me know!
