Redcon,
I have a fairly high set of yellow metal ramps. (I think from Trak Auto) In order to use them I had to make some pre-ramps. I just cut a 2x12 board into 18'' pieces and put a 30 degree bevel on both ends. If you stack two boards for each ramp, it works perfectly.

Bad ASCII diagram...

Code:
Pre-ramps:
_____________
\_____________\
 \_____________\

Regular ramp and pre-ramps:
_________________
|                \
|                 \ ____________
|                  \\___________\
|___________________\\___________\

96 Contour GL (2.0L Zetec, ATX)

Sony CDX-C780 HU, Sony CDX-805 10 disc Changer, Sony XDP-210EQ, RF Punch 100.2 Amp, RF Punch 240.4 Amp, Dual 12'' Punch subs, Four Infinity Kappa 693.3i 6x9's, Optima Yellow Top

CTA Intake, Hood Struts, EL Ford Logo, Hi Beam/Low Beam Mod, Blue LEDs in door handles and footwells