Quote:
Originally posted by Sleeper:
Quote:
Originally posted by LoCo:
[b]But what if I want to off road my Zetec? :p
Why? Have you done a AWD/4WD conversion?
[/b]
I haven't got AWD, but I do have a two inch deep dent in the sheet metal under the driver's foot area -- it makes a noticeable bulge in the carpet, which I ought to pound down one of these days -- and I also have lots of nicks and dings on the bottom of my tranny, from just one drive over a particular dirt road that was covered with chunks of lava.


96 GL Zetec ATX, white with pinstripe, nickname " Sam Smooth "
mods so far: CTA intake with homemade heat shield, KVR drilled front rotors & carbon pads w/ 500° fluid
planned mods: exhaust (want to keep it quiet), e-ram (awaiting installation), diablo chip
involuntary mods: compression increased after head gasket failure