Quote:
Originally posted by DavidBC:
Maybe my best choice would be to replace the black sewer (clean BTW) pipe with some 3" dia. stainless exhaust pipe. We'll see.
The plastic is much better insulation. I almost made an intake out of ABS myself, rather than getting the CTA, but I couldn't find an elbow I was really happy with, and I was hoping to get a 2.5" diameter pipe instead of 3", this being a better match to the TB and MAF.

96 GL Zetec ATX, white with pinstripe, nickname " Sam Smooth "
mods so far: CTA intake with homemade heat shield, KVR drilled front rotors & carbon pads w/ 500° fluid
planned mods: exhaust (want to keep it quiet), e-ram (awaiting installation), diablo chip
involuntary mods: compression increased after head gasket failure