Well, it went on today on labelle's Contour and the fitting went great. There are 2 differences that were taken care of. The main one, the IAT, needed a 5/8" hole drilled. From there the aluminum is soft enough that you can thread the IAT in about 2 threads, into the hole. This is more than enough to hold it. Just need to make sure the orientation is correct.
Second issue with the crankcase breather, also taken care of. We need to use a fitting that goes from 1/2" to 3/8", reuse the existing crankcase breather line, and extend it with some additional hose, clamp the end to the intake tube, and that's it.
The rest is the same as the after 98 kit. Best of all, the hood height of the pre 98's gives more clearance for the intake too.
All and all, a very good install. Now the catch is that our suppliers have backlogged many of the parts we need to build the kits and we will be delayed by about a week or more before we can get the kits out.
Sorry about that.
