Contour Enthusiasts Group Archives Forums General Group Buy Oval Mesh Grille Material

Well I have installed the front lower Mesh. Here is how I did it.
1. Remove the plastic air deflectors for the Radiators and pull the grill out by removing the clips.
2. I used the grill to draw directly onto the new mesh the spots where the tabs will go through.
3. As someone else said earlier, I used the dremel to cut slots into the new mesh. I went out and fit it on.
4. I wanted to use the air deflectors for the radiators so instead of bending the new mesh over I left it on flat. I took the old plastic grill and cut the grill work out of it so I had just the outline of the grill with the mounts for the air deflectors in place.
5. I now just used the same tabs and put the plastic piece on behind and new mesh and used the retaining clips. Then I simply screwed back on the deflectors and put the rest back together.

This worked out very well and I am very happy with the way it looks and functionally nothing changed. The principle is basically the same for what was recomended for the top oval grill.

Hope this helps somebody.