Mad Mole's Mondeo: He installed them without drilling and he seems to think that we won't either, since he said that we have bolts in the same place.
Heres his install notes below:
Required Tools: 10mm open ended spanner
Time Required: 20 mins
Supplier: Performance Solutions , tel 01604 232003
Pop the Bonnet and tighten the bottom two alignment bolts on the hinges
Remove the top two bolts on the hinges (that's why we tightened the bottom ones, so the setting cant change)
Screw into these holes the two strut ends that have the threaded bolt (not the self taping end), tighten with the spanner. Dont forget to use a washer
Undo the middle of the three wing retaining screws (level with the coolant reservoir)
Screw the two self tapping end into these holes again using a washer (watch out for wires underneath)
Screw the thin end of the gas strut into the top fitting
Screw the bottom end of the gas strut into the bottom fitting (lift the bonnet higher to do this) making sure the top is held and doesn't unscrew
Stand back and admire
Does that help?
