|
|
Joined: May 2004
Posts: 3,637
Hard-core CEG\'er
|
OP
Hard-core CEG\'er
Joined: May 2004
Posts: 3,637 |
IM attempting to take my wheel bearings out myself this weekend. So i got everything to the tie rod-end bolt removal.. Now i put the nut back on the bolt to get the tie rod loose by banging on the nut. I got it loose.. but now the nut just moves with the bolt in the tie rod end.. I cant even tighten it back up.. it just spins.. I NEED HELP.
99 TRed Contour SVT # 1853 out of 2760
230.2 WHP @ 6500
237.0 WTR @ 2250
Originally posted by MxRacer: Originally posted by RawBurt: I'll be keeping it to myself, until the time comes. It'll be hard to find.
much like your weiner.
|
|
|
|
Joined: Dec 2001
Posts: 6,910
Hard-core CEG'er
|
Hard-core CEG'er
Joined: Dec 2001
Posts: 6,910 |
the bottom of the bolt should be keyed for an allen wrench to stop the bolt from spinning so that the nut can spin ...
- 95 Mystique LS - Zetec/5spd
- 99 Contour SeVT Sport - Duratec/5spd
Official NE-CEG Contour/Mustang Family
|
|
|
|
Joined: May 2004
Posts: 3,637
Hard-core CEG\'er
|
OP
Hard-core CEG\'er
Joined: May 2004
Posts: 3,637 |
99 TRed Contour SVT # 1853 out of 2760
230.2 WHP @ 6500
237.0 WTR @ 2250
Originally posted by MxRacer: Originally posted by RawBurt: I'll be keeping it to myself, until the time comes. It'll be hard to find.
much like your weiner.
|
|
|
|
|
|