Alright, I'm putting my trans in right now and am stuck. Right now the transmission is all bolted in, p.s. lines are attached, shift cables attached, subframe attached, and the rear roll restrictor bracket is attached. Now I just put pole's poly mount in but everything doesn't seem like it is lining up like it should. I'm trying to get everything straight but its not going so hot. Do you need the powertrain alignment tool to take over the front motor mount, even if you have poly filled front and rears? After I get everything lined up and bolted in the rest should go quickly but I'm stuck right now. Can anybody help me out a bit?

A few pictures that might be of some assistance







Alex 00 T-Red/Tan SVTC #1964/2150 167 HP @6800 153 TQ @3000 Sold- 98 'Tour SE 24V 5-spd 149 HP @5900 148 LB FT @4300