My Powerbuilt torque wrench from Kragen is a $45 piece of dung. I set it to 7.4 ft-lb. (10 N-m) and it never clicked before I snapped this bolt on the front (right) valve cover (bolt #1). I know, I should have been more aware of how tight I was tightening it. Never trust tools purchased from Kragen.
Can someone please help me with these questions:
1) What tap set do I need for this? Any tips on tapping this bolt would be greatly appreciated.
2) Can I reuse the gasket since I put the silicone on it already? I wiped it off as best I could.
3) In the lower picture, should the gasket go under the bolt washers or above?
4) Can someone recommend a good brand torque wrench under $60? The Craftsman from Sears seems good for $60.
