So I've had the 65mm T/B on for some time now. The problem is, where the throttle cable pin slides into the T/B cam. When accelerating, it pulls the cable tight, and then letting off on the accelerater, it loosens it back up. Well the issue is, this causes the cable to get weak, and then start to break. Well I just noticed today, that my cable is hanging on by 2 strands. Any of you guys running the 65mm T/B, did you replace the cable pin, with something else, to avoid this? I'll take a picture of it as soon as my camera charges. To get an idea of what I mean, if you take a wire and keep bending it back and forth, back and forth, over and over, it will eventually break. It's breaking right at that slider pin that goes into the T/B cam.
Mark
