|
Joined: Jun 2006
Posts: 227
CEG\'er
|
OP
CEG\'er
Joined: Jun 2006
Posts: 227 |
maybe i was just born yesterday, but what were you thinking warmonger? i feel betrayed!
why would you sell the CSVT!!!!
1998 CSVT
NX stage 1 ford EFI kit
MSD dis-4
B&M short throw
K&N short ram intake
Fsvt Euro 17's
Trubendz 2.5" exhaust
Spec stage 3
249.9 HP 258.2 TRQ clutch slipping the whole time
|
|
|
|
Joined: Nov 2003
Posts: 4,051
Hard-core CEG\'er
|
Hard-core CEG\'er
Joined: Nov 2003
Posts: 4,051 |
|
|
|
|
Joined: Jul 2001
Posts: 7,100
Addicted CEG\'er
|
Addicted CEG\'er
Joined: Jul 2001
Posts: 7,100 |
He sold it because he chose to...
because he had built an incredible machine.. and because he was at a point in his life that he knew he had bigger and better plans!
That, and because I wanted to buy it!
'99 CSVT - Silver #222/276
In a constant state of blow-off euphoria.
Originally posted by Kremitthefrog: I like to wear dresses and use binoculars to watch grandmas across the street.
|
|
|
|
Joined: Jun 2006
Posts: 227
CEG\'er
|
OP
CEG\'er
Joined: Jun 2006
Posts: 227 |
cool. anybody know what his bigger and better plans are??? oh and yeah i dont PM him because he doesnt check them much anymore it seems and this is easier, talking to you folks oh and ray, i am supposed to ask how much its going to cost for a schematic of your turbo mani setup off that car!!!!
1998 CSVT
NX stage 1 ford EFI kit
MSD dis-4
B&M short throw
K&N short ram intake
Fsvt Euro 17's
Trubendz 2.5" exhaust
Spec stage 3
249.9 HP 258.2 TRQ clutch slipping the whole time
|
|
|
|
Joined: Jul 2001
Posts: 7,100
Addicted CEG\'er
|
Addicted CEG\'er
Joined: Jul 2001
Posts: 7,100 |
Originally posted by TRicker: cool. anybody know what his bigger and better plans are???
When it comes to Tom, you can NEVER TELL!!!! He'll surprise anyone, I am sure, when he gets in to a project!
'99 CSVT - Silver #222/276
In a constant state of blow-off euphoria.
Originally posted by Kremitthefrog: I like to wear dresses and use binoculars to watch grandmas across the street.
|
|
|
|
Joined: Sep 2000
Posts: 7,025
Hard-core CEG'er
|
Hard-core CEG'er
Joined: Sep 2000
Posts: 7,025 |
Ray, when did you get new dyno numbers? Are they official?
Jim Hahn
1996 T-Red Contour SE Reborn 4/6/04
3.0L swap and Arizona Dyno Chip Turbo Kit
364 whp, 410 wtq @ 4,700 rpm
|
|
|
|
Joined: Aug 2004
Posts: 5,882
Addicted CEG\'er
|
Addicted CEG\'er
Joined: Aug 2004
Posts: 5,882 |
Originally posted by SVT4STD: PM's are cool.
meh, over-rated
i am personally a big fan of the "shout out!" HOLLAAA!
Originally posted by Tourgasm:
Sometimes you can mess up a word so bad that spell check doens't know what the hell you're talking about.
|
|
|
|
Joined: Jul 2001
Posts: 7,100
Addicted CEG\'er
|
Addicted CEG\'er
Joined: Jul 2001
Posts: 7,100 |
That's a gray area. I had a minor problem on the car, and once out of the shop I dyno'd to make sure it was where I was when I put it IN the shop. I went ahead and popped off a 14psi run to see where I stood.
Since that run, I have been talking with Tom about trying to get the car's tune shifted a bit, as I am now running rich, (faulty MAF replaced, threw off the tables, slightly)
I don't have a scan of the dyno sheet to post, but could always get one. I can't, however, swear that it would pull that again (right now) with it running rich. I think after I get it dialed in a little tighter, I will dyno again, and see what I can top, then.
So, the numbers were "officially" done, but aren't officially posted, as I don't have the scan of the sheet available.
'99 CSVT - Silver #222/276
In a constant state of blow-off euphoria.
Originally posted by Kremitthefrog: I like to wear dresses and use binoculars to watch grandmas across the street.
|
|
|
|
Joined: Feb 2003
Posts: 710
Veteran CEG\'er
|
Veteran CEG\'er
Joined: Feb 2003
Posts: 710 |
Originally posted by TRicker: cool. anybody know what his bigger and better plans are???
oh and yeah i dont PM him because he doesnt check them much anymore it seems and this is easier, talking to you folks
oh and ray, i am supposed to ask how much its going to cost for a schematic of your turbo mani setup off that car!!!!
Dood... with warmonger being the great guy he is, he has many pictures and details freely available on his site.
morbid
2000 Contour SVT (black)
|
|
|
|
Joined: Oct 2000
Posts: 6,760
Hard-core CEG'er
|
Hard-core CEG'er
Joined: Oct 2000
Posts: 6,760 |
if those numbers in your sig are it, than thats badass for stock internaled, homebuilt turbo car
Ryan
Trollin!
|
|
|
|
|