I already put a small split in a cv boot. I used some high temp RTV to fill it in (not sure if this will hold). So you guys pound on the hub to push it in?
I guess I can put a little more detail onto the situation. This is still part of my clutch/flywheel replacement project. As it sits everything has been reinstalled except the passenger side half shaft needs to be put in and the steering rack needs to be clamped back down to the steering column.
So would the best way to put this thing back on be to disconnected the passenger side brake caliper, strut and hub and just pounded on the end of the shaft?
-Mike
98 Contour SVT
Toreador Red #49 of 6535 Built on 3/25/97
WR Headers, Borla Cat-Back, Torsen T2 LSD, K&N Short Ram, S-AFC and Focus Shift Tower
85 Camaro
1969 358ci, 97 TA interior, 91 Z28 GrdEfx and Aero Wing 255rwhp
| 
