Alright I have my drivers side half shaft installed but my passenger side is not working with me at all. With the driver side I was able to pound on it with a hammer to push the clip in, but the passenger side has nothing to pound on. I tried propping a big creset wrench on the end of the half shaft where it enters the transaxle, and resting against the subframe then pounding on the end of the wrench to push the axle in. Despite the sweat and blood it didn't work. Any other ideas?
I searched and found only a few posts, but none of them really talk about a fool proof way to install them correctly with little to no hardships.
-Mike
98 Contour SVT
Toreador Red #49 of 6535 Built on 3/25/97
WR Headers, Borla Cat-Back, Torsen T2 LSD, K&N Short Ram, S-AFC and Focus Shift Tower
85 Camaro
1969 358ci, 97 TA interior, 91 Z28 GrdEfx and Aero Wing 255rwhp
| 
