Originally posted by scottd60: I would recommend going to 100 deg countersink/flathead screws. You will like the results much better...less invasive to the TB shaft and better hold on the thin .062" TB plate
I've noticed this, and was looking into a 90degree 30%reduced height fastener, but can only locate them in standard thread, no metric.
In addition i was only able to locate standard thread for 100 degree screws.
So in both cases(90 or 100 degree) i'm stuck with what i've got at the moment untill i can locate a supplier for either of the two options, it works well but i am on the lookout for another method.
99 SE V6\5spd - 156 HP\157 TQ 15.166-90.84
Totaled 02/12/06
99 SVT # 1571 - 175 HP\153 TQ 14.999-91.88
Born 3/24/99 Reborn 3/18/06
Pietenpol Racing Technologies project vehicle
90 Festiva L 5spd, Blue(not for long), 103k
|