Originally posted by Buckshot77:
Gaskets- $200 +/-
Bearings $75
Head bolts or studs- $50-150
New timing assemblies- $300
DMD- $75
Flywheel- $200
42lb injectors- $200

Now tell me that you're going to pay yourself $5-10/hour to do all of that work as to do everything properly and get all of the build quality you get with one of their engines, you should spend 50-100 hours on your build and head PnP.

Rick


Not To Mention The Cam Grind...Or Is This An ST220 Cam Basically?
If Not You Have To Assume Around $750.00 For Cams From Ford.UK Or Around $300.00 For A Grind (Wouldn't Do That In An Engine With Such Tolerances Or High RPM Anyway) And That's Being Conservative.

Tom, I Bet It Could be Reproduced For Around $3500-$3900 Per Longblock, But Not Half Price. I Do Know However, That You Would Be One Of The Best Candidates For The Job.
Between You And Rick, I Bet It Could Be Done In This Price Range And Done With a High Level Of Quality. <insert>:asskissinggraemlin:

CSVT E0 3L 14.5 @ 94mph, Stock Intake, Stock Exhaust minus Resonator, CEL, And Broken Pass. Side CV...Untuned.