Has anyone had to use this tool replacing tie rods or is there another method? (Taken from the Ford CD)
Tie Rod End - Outer
Special Service Tool(s)
Separator, Ball Joint
TOOL-3290-D (211-001)
Removal
1. Raise and support vehicle. For additional information, refer to �«Section 100-02�».
�µ 2. Loosen the tie-rod end locknut and retaining nut.
1 Loosen the locknut.
2 Remove the retaining nut.
�µ 3. CAUTION:
When the tie-rod end is separated from the wheel knuckle the ball joint should be protected to prevent damage.
Using the special tool, release the tie-rod end from the wheel knuckle.
�µ 4. Note:
Make a note of the number of turns required to remove the tie-rod end.
Remove the tie-rod end and locknut.
1 Remove the tie-rod end.
2 Remove the tie-rod end locknut.
Installation
�µ 1. Note:
Make sure the tie-rod end is secured by the same number of turns used to remove it.
Note:
Install a new retaining nut.
Install the tie-rod end and locknut.
2. Check the toe adjustment. For additional information, refer to �«Section 204-00�».
