Originally posted by Mustang:
Press the bearing in from the outer shell(race)only.
On wheel bearings inside of the rotor, I heat the rotor to 250-300 deg F and freeze the bearings. They pretty much drop right in  . But that's a bit off topic.
What about the hub? Yes you need to support the inner race when you press the hub into the bearing. 
2000 SVT Turbo 295hp/269ftlb@12psi
#1 for Bendix Brakes Kits!
Knuckles rebuilt w/new bearings $55
AUSSIE ENDLINKS $70
Gutted pre-cats $80/set
A lack of planning on your part does not constitute an emergency on mine!
| 
