Originally posted by mean'tour: All right, worked most of the day on the starter. Got it out and replaced. STILL NO START!
I was going through all the things people told me to check, and remembered that I had forgotten the Clutch sensor/switch. I bought one at AZone but it didn't fit and then it slipped my mind.
Now I'm desperate. I will find and replace them. There are 2 of them. They seem to work against each other one moves out as you depress the clutch and one moves in. Which should I replace?
If that doesn't make any difference, what's next? How do I test the wiring to make sure power is getting to the (new) starter?
Then what?
Here is a photo (excuse the quick drawing) of the switches/ sensors I found. I tried to replace the red one with the one AZone sold me, but the stock wiring didn't fit.
As the clutch pedal is depressed the gray plunger on the red sensor opens up/ moves out, and the gray plunger on the black sensor closes/ moves in.
The numbers listed on the parts are:
Red: 95BB-7C534-AC (I think, it is really hard to read) and P6M GA
Black: 94BB-11A152-AB and P6M GA.
That 2nd number confuses me as there is no way they are interchangeable. But that is what my local CAP store told me.
I've not had any luck with any of those part numbers at: www.teamfordparts.com either. Any ideas?
MUST SELL - ECM computer new for a 98 V6 mtx + pats
Now trolling in a Red Nissan 4 x 4