Originally posted by SHOgoFast:
I may just be an idiot but I cannot seem to figure out what I am doing wrong here. I assemble the fittings as instructed and can very very easily still pull the tube from the fitting. Here are some pictures.

This is the order in which i assemble the parts...

everything all tightened up...

can simply pull the tube out of the fitting...



I believe the instructions said not to overtighten the fittings, something like 1/4 turn after snug.




Well guy your either not tightening them enough or your using a 1/4" fitting instead of an 1/8". After you tighten it does the brass compression fitting look crushed?

Mike

The ONLY 96 (engine) 3L Build 'em fast. Spray 'em faster. ricehatersclub.com