FWIW, the MS3 is coming to party with 247 hp/280 ft/lbs of torque this fall to compete with the Calibers 300/260, should be a good one
I thought it was funny that the MS6 has 274/280, then they de-tune the motor a little, switch the hp numbers around on us (274 vs. 247) but keep the torque at 280 ft/lbs, how can this be
Its said that the MS3 is going to cost about $25K, so its a little higher than the Caliber SRT-4, but I bet if you compare them with the same options or close enough anyway, its going to be close.
