Originally posted by SVTCJ:
Originally posted by 1slosnake:
Yours was that bad. Did you put the kit on piece by piece? Fitment wasn't the best but I was able to bend the pipes just a touch to make it work. I agree it is a little ricey. Especially when the Secondaries open up.
My passenger side tip extended out 4 inches further than the driver side.
My driver side is actually a little too short. I had the passenger side cut to match the driver side. If I pulled the driver side out to where it looked right it exited at an angle. Not much room for length adjustment due to the "T" piece that both tips come out of.
If I'd had my druthers, I would've cut the passenger side 3 inches and extended the driver side 1 inch. Too much $$$ after already paying for the exhaust.
Should've bought a better exhaust to begin with. And resonated!
Live and learn.
Man if it was that bad, you should have sent it back. You did put on piece by piece right? Starting from the Y pipe to the back. I had to manipulate some of the pipes length where they connected to make it work out.
98 CSVT E1
Previous Rides
03 Cobra
544rwhp & 585rwtq
10.89 at 135
97 Mustang Cobra P1SC intercooled
460rwhp & 412rwtq
11.47 at 120
89 GT w/347 mid 12's
99 Lightning mid 12's
95 Cobra Low 12's
I'm a sucker for speed 
| 
