Originally posted by TourDeForce:
Originally posted by LocoGSR:
Originally posted by striker2:
Originally posted by LocoGSR:
Originally posted by TourDeForce:
(* [Subliminal message] MAKE IT FIT THE ATX CARS TOO [/Subliminal message] *)

What was that? Anybody hear something???



*It will break your ATX*



it probably would but if we had a donner car that we could dyno for the chip we could de tune it some so it wouldnt be so hard on the tranny.

as for fitment it should fit the atx just fine.

The torque any turbo would create would break it.



It would make YOUR CD4E break. Not mine. Your kung-fu is not strong.

A little more thinkin' outside the box Hector & you'll get it. You were already thinking outside the box with your supercharger project and did an excellent job with it. Quite exciting to hear/see the teaser vids you made. I'll be taking things with a turbo & tranny in slightly different directions, so I should be able to manage the turbo power & ATX functions to a point where it will last a few years minimum. If not, I'm prepared to replace the tranny without b[self-sensored]g about it.

Good to hear. Just make sure to add the ATX cooler (couldn't remember if you did or not) and change the fluid more often. If you go turbo make sure to have a chip done to firm up the shifts/raise the shift points to take advantage of boost.

Hector 2003 Rally Red Mitsubishi Evolution VIII 257HP/259TQ 2005 Lapis Blue Mazda 6s RET: 00 Cabernet Red Ford Contour Zetec ATX SUPERCHARGED 160HP/141TQ