Register Log In

Contour Enthusiasts Group Archives Forums General Troubleshooting Jesse James and DTC 332

Print Thread

Jesse James and DTC 332 #1525846 03/14/06 01:05 AM
Joined: Nov 2001 Posts: 1,176 Austin, TX. B btrautman OP CEG'er
OP btrautman CEG'er B Joined: Nov 2001 Posts: 1,176 Austin, TX.	I have the wonderful DTC 332 code. Checked egr with suction test and engine did die as supposed to. Vacuum harness is in new condition. EGR vaccum solenoid tested fine. Replaced Vaccuum solenoid (down by DPFE) and replaced DPFE. Hoses to DPFE are generic hoses FORD sold to me....not like the original ones. Precats were replaced about 2 years ago. Pulled upper intake and removed throttle body, still very clean from last time removed. Any ideas appreciated.... Bob An ounce of prevention provides a pound of cure!

Re: Jesse James and DTC 332 #1525847 03/16/06 01:49 AM
Joined: Nov 2001 Posts: 1,176 Austin, TX. B btrautman OP CEG'er
OP btrautman CEG'er B Joined: Nov 2001 Posts: 1,176 Austin, TX.	Well I found the problem. I went out and again purchased two new DPFE hoses and put them on. Problem is now gone......... Can't figure out what was wrong with the first set.... Bob An ounce of prevention provides a pound of cure!

Re: Jesse James and DTC 332 #1525848 03/16/06 01:53 AM
Joined: Jun 2005 Posts: 5,345 Virginia, USA T Tony2005 Addicted CEG\'er
Tony2005 Addicted CEG\'er T Joined: Jun 2005 Posts: 5,345 Virginia, USA	LOL. Eventually, you find the solution to your problem. Thanks for posting your solution, Bob. "Always do the cheap and easy ones first." 1996 V6 ATX 96K miles

Moderated by horseydug_dup1, Ray_dup1

Link Copied to Clipboard

Powered by UBB.threads™ PHP Forum Software 7.7.5