Wow Judge, I dont even know where to start. But I seriously just laughed so hard at that.
Quote:
I wish I had pictures of the ones I made for Stazi
From what I understand it couldnt of been that great if stazi ended up builing his own. So he told me.
Quote:
one right hand thread and one left hand thread so you could adjust tension and then lock it in
Yup same here, such a genious concept huh?
Quote:
The end brackets were .125" steel
Another tough concept, steel for the end plates... Same here
Quote:
The bar was 5/8" 6061 T6 Aluminum drilled and tapped accordingly
Wow, exactly what I used as well
Quote:
the one I made is alot stronger than the one in the GB and yes...I am a welder and machinist....
Back up what you say or shut up. What you just explained is almost identical to what I made. My welder does a very good job, for this particular work, its not rocket science.
Quote:
and I break stuff for a living so I know how to deal with tensile strength of materials.....
Its funny that you say that, becuase so do I. I am a test technician/ engineer for TFS. So dont try to talk to me about tensile strenths and what not.
