I wish I had pictures of the ones I made for Stazi, myself and soemone else. I used aircraft Heim joints (one right hand thread and one left hand thread) so you could adjust tension and then lock it in. The end brackets were .125" steel and I used shoulder bolts to go through the heim joints. The bar was 5/8" 6061 T6 Aluminum drilled and tapped accordingly to the Heim joints. Sorry...the one in the GB looks like a 5 yr old did it...and it is a bad copy of the ones already been made. Ya want mine...you are looking at about 150ish in materials plus som labor (I taper the ends of the bar to clean it up, plus they need to be drilled and tapped all done on a lathe and I will have to make the end brackets as I do not have any left)....so whatever.....let mee se how much the heim jts are this year....maybe less....but I doubt it....but I will tell ya....the one I made is alot stronger than the one in the GB and yes...I am a welder and machinist....and I break stuff for a living so I know how to deal with tensile strength of materials.....
