Originally posted by morbid: Perhaps the easiest modification to the UIM would be to cut off the long edge of each plenum... weld on a 2-3 inch extention then weld the edge back on. Of course there would now be rough material inside the plenums, but a cycle through extrudehone would help with that.
So just a dead end extension on the end of the plenums?
I was thinking the best way to increase the plenum size was to pretty much model after the SHO intake. They're plenum made a complete loop and essentially connected all of the runners to a big 'O' shapped plenum. Like this:
-Mike
98 Contour SVT
Toreador Red #49 of 6535 Built on 3/25/97
WR Headers, Borla Cat-Back, Torsen T2 LSD, K&N Short Ram, S-AFC and Focus Shift Tower
85 Camaro
1969 358ci, 97 TA interior, 91 Z28 GrdEfx and Aero Wing 255rwhp
|