Today I removed the IAC and cleaned it out. Rather clean though. I also located the hose coming out of the PCV. With a visual inspection the hose appearred to be fine without removing it. There was some gunk around the gromet however. The IAC valve did not have a gasket when I removed it either. The wires and coil appear to be fine. I will replace gasket to IAC and check the grommet and PCV hose tommorrow(eventhough looked fine). Any other suggestions would be appreciated.
No new codes since cleared(1131, 0304)
Still very rough idle and will stall when rpm's reach idle speed after start up.
