Originally posted by giddyup306:
I used the stock SVT springs. You have a non svt correct? If so, check them with a spring tension gague and use the heavier springs. I forget what the SVT springs were..... But (just a SWAG) I think that the 2.5 and 3l springs should be the same strength.
Another option is the ST200 springs. However, sources tell me that they are probably not any stronger than the SVT springs...
The Spring Rate For The 2.5 SVT Valve Springs Are 153 Lbs And The ST220 Valve Springs Which...DO FIT, Are Rated At 163 Lbs. And You Can Get Them At Any Ford Dealership. Should Cost Somewhere In The Range Of 60 Bones To Own Them.
Sorry I Dont Remember The Part Number But You May Find It In The 3L Part Numbers Stickie.
As Far As Saving Some Parts Off The 3L, Id Save All Of The Sensors That You Can...ECT Sensor, Knock Sensor, Et Cetera.
Her Is The Link To The Valve Spring Part Number: Click This And Like It!!!
Last edited by Pale Horse; 02/18/06 12:42 AM.
CSVT E0 3L
14.5 @ 94mph, Stock Intake, Stock Exhaust minus Resonator, CEL, And Broken Pass. Side CV...Untuned.
| 
