Contour Enthusiasts Group Archives Forums Modifications Forced Induction Fuel line for nitorus kit

Originally posted by PEWTNERST24:

---

Thanx for the reply and the advice but do you know where i can get the brass reducer piece as i have had no luck locally
I dont want to cut my fuel line and put the barbed t-piece in as i may want to put it back to stock one day and it looks neat off the fuel rail.

Mark

---

I got mine at Ace Hardware in the brass plumbing fitting. I guarantee that Home Depot has them too, they have a nice small brass plumbing section and that type of fitting is standard. Easy to find. Just shut down the car, pull the fuel pump fuse and run the car till it stop to burn up the fuel under pressure in the fuel rail.
Then unthread the stock fuel port fitting (schraeder valve) and take it with you to ACE or Home Depot and find the A/N fitting that has the same end. Easy. Cost you like a buck plus time and gas to go get it.
While there, get a pice of brass and another end that will allow you to T off a fuel pressure sensor before it goes into the fuel solenoid and then wire the sensor in series with the Nitrous solenoid.