I am a proponent for the FMS wires too.

BTW Todd - the common misunderstanding is that the overall diamter of the wire is proportinal to the resistance - this is WRONG. The conduit is in the very center and is MAYBe 1mm wide at most. the rest of it is just RFI suppressant. So 10mm or 15mm wires won't have any lower resistance than the 8mm wires. That is not to say all wires are the same as the quality of the actual conducting center wire affects the resistance AND some "big" wires have crap insulation which allows arcing and RFI.

2000 SVT Turbo 295hp/269ftlb@12psi #1 for Bendix Brakes Kits! Knuckles rebuilt w/new bearings $55 AUSSIE ENDLINKS $70 Gutted pre-cats $80/set A lack of planning on your part does not constitute an emergency on mine!