No pics yet, I'll try to snap a few tommorrow. I didn't replace the knucle bushing becuase I still need to swap in my dics brakes (I know I know). Here's what I did.
1) with control arm off of car, drilled holes in the rubber around the inner most sleeve, then used a propane torch to burn into the drilled holes.
2) pressed out the inner sleeve and some rubber with arbor press.
3) used a propane torch and burnt out the remaining rubber
4) used a die grinder to remove any residue and polish the inner shell( I removed quite a bit of material from the shell's edge to camfer it)
5) using arbor press and lots of liquid wrench lubicant pressed in the new bushings.
It was a very snug fit.
