Originally posted by Buckshot77:
I'm also going to check and see if it is possible to sand out the back to fit the curve. I also think a little black paint on those edges would be pretty decent looking.
Rick
My set are a "new version" which are
slightly thinner, but still too thick.
Here's what I did:
The CF panels are layers of material, so I used a razor blade (the kind with a blade that you can break off a section at a time). I extended it pretty far and carefully cut off 2 layers.
It's thinner, and looks better.
I'm concerned about warping, so I plan on using epoxy.
